Surface preparation is critical to the outcome and longevity of the surface finish. All surfaces to be coated with Monocel Water Based Wipe-On Gel Stain should be clean and dry, free from wax, oil, grease and other contaminants. Fine sanding with 240-grit sandpaper, rounding off all sharp edges and corners, then thoroughly dust prior to application. A tack rag is recommended for dusting.

All previous paint, varnish, shellac or lacquer must be totally removed and stripped back to bare timber before coating with Monocel Water Based Wipe-On Gel Stain. If the surface has been previously coated with Monocel Water Based Wipe-On Gel Stain, the surface should be sanded back lightly removing and lifted or cracked film and thoroughly cleaned before re-coating.

Ensure adequate ventilation during use.

ALWAYS test the product on a small inconspicuous area or off-cuts first to ensure the product does not react adversely with surface and ensure the product is suitable for your specific requirements.

Shake bottle before use. Squeeze out onto rag (Do not squirt directly onto timber)
Apply while undercover and out of direct sunlight. Using a clean, lint-free rag for application. Fold rag to expose a small corner for controlled application. Invert bottle and rag to transfer stain.

Apply stain evenly to timber surface using circular or linear strokes.Work in manageable sections to maintain a wet edge. Wipe off excess stain. Apply subsequent coats in 2 hours if a deeper colour is desired, following the same procedure.

Allow stain to dry for minimum of 2 hours, If you are satisfied with the colour, coat immediately with varnish, wax our oil. If you would prefer a richer colour, Apply additional coats. Leaving freshly stained timber uncoated will cause the stain to dull