Stir contents thoroughly before and during use using a broad, flat paddle in an upward motion. Insufficient mixing can result in inconsistencies of the finish. DO NOT SHAKE the contents as shaking will produce air bubbles which may become trapped on the surface during application.

For best results Paving & Concrete Sealer Satin should be poured into a pump action pressure sprayer (like a garden sprayer used for pesticide applications) or a roller tray and applied using a good quality roller.

Apply Paving & Concrete Sealer Satin evenly, doing 1 square meter at a time. If using anti slip additive broadcast evenly over the wet first coat before leaving to dry. The second coat should be applied at an angle opposite to the first coat, once the first coat has dried (24hours)

It is also advised to lay-off with your roller, this is achieved by making sure the final stroke is pushed away from you then lifted off the surface. When you pull the roller towards you it reverses the nap resulting in roller marks. Allow 24 –hours drying before applying the second coat.

Paving & Concrete Sealer Satin is film forming however the coverage rates will vary depending on surface porosity, surface application must meet a minimum of 5 m2 per Litre for the first coat, the second coat will have an increased coverage rate.