Bondall Epoxy Prep
Bondall Epoxy Prep Surface Conditioner has been specifically formulated as a waterproofing substrate conditioner prior to
applying Bondall's range of products, namely Aquatite, Pondtite, Terratite, Polyurethane Paving Paint, Decorative and Architectural Paints and Coatings. It can also be used as a water vapour barrier coating prior to laying floor coverings such as
carpets, timber flooring, tiles etc.
Features & Benefits:
Bondall Epoxy Prep Surface Conditioner is environmentally friendly and is the ultimate water borne epoxy coating system
available prior to using the Bondall range of water based liquid applied waterproofing membranes and conventional paints.
Its intended uses include but are not limited to the following:
- Bondall Epoxy Prep is the ultimate surface conditioner to be applied to surfaces that are less than desirable prior to
applying Aquatite, Pondtite or Terratite.
- Bondall Epoxy Prep is a barrier against rising damp especially in installations where there is uncertainty of the use of
polyethylene builder's films or where there is a chance or a known source of continued renewable moisture causing osmotic
pressure, prior to applying Aquatite, Pondtite or Terratite or conventional paint systems.
- Bondall Epoxy Prep is excellent for stabilising dust and loose surfaces prior to applying conventional paint systems or
other toppings or coverings such as tiles or carpets.
- Bondall Epoxy Prep can be used as a tie-coat (intermediate coat) when Aquatite, Pondtite or Terratite or other conventional paint system is applied to surfaces previously coated with bitumen based coatings.
- Bondall Epoxy Prep can be applied to harden green concrete or damp concrete prior to applying Aquatite, Pondtite,
Terratite or other conventional paint systems. Typically allow newly poured and laid concrete to cure for between 8 to 12
hours prior to applying Bondall Epoxy Prep.
- Bondall Epoxy Prep has tenacious adhesion to brick, concrete, cement render, masonry, masonry blocks and compressed fiber-board/sheet and subsequent coatings.
- Bondall Epoxy Prep can be applied to damp substrates prior to application of conventional paint systems, timber
flooring, tile adhesives or carpet.
- Bondall Epoxy Prep can be over coated with cementitious products after curing ie. tile adhesives or floor toppings.
Sizes:
2 and 4 Litre packs.
Applications
Applying a waterproofing substrate conditioner (EpoxyPrep).
More Information
For further advice contact the Bondall Building and Renovating Service on 1800 810 123 or (08) 6272 3800
