General Application of AquaPutty

Product: Bondall AquaPutty

Surface Preparation for General Application:

• Make surface rough with sandpaper or steel brush

General Application:

• Clean surface using steel brush, or sand paper. 
• Cut the required amount of AquaPutty.
• Knead it until homogeneous colour is achieve.
• Place AquaPutty on surface immediately. 
• Apply pressure with fingers.
• After usage wash hands with soap and water.

Notes: When repairing pressurised leakages, close off with wooden plug. Then apply AquaPutty and fixate with fingers or tape after a couple of minutes.
Ready to paint directly after applicatio
To get a smooth result: rub surface with wet finger or moist cloth immediately after application.

Drying Time

• Working time after kneading: 3 minutes by 20°c
• Hardening time, standard: 15 minutes by 20°c
• Under water: 20 minutes by 20°c

Precautions/ First Aid

Irritating for eyes and skin. Contains Epoxy. Recommended to use with gloves & eye protection. Any eye contact to be washed thoroughly with plenty of water. Keep out of children’s reach.

• If accidental poisoning occurs, seek urgent medical advice or contact the poison Information centre on 13 11 26.
• Material safety Data sheet available on request.