Bondall Tile & Grout Cleaner Applications

Applications

TEST AREA: Always test on a small inconspicuous area, to ensure that the product is achieving the desired result, prior to application over the entire area.

• Apply Tile & Grout Cleaner to the affected area and work vigorously with a stiff brush.
• Leave for 5 – 10 minutes, then wash away with water, but never allow drying out. • For heavily soiled surfaces, application may need to be repeated until the stain is removed.

NOTE: When applying Tile & Grout Cleaner near lawns and gardens, be careful not to splash onto plants. Should this happen, rinse thoroughly with water to neutralize Tile & Grout Cleaner.

Coverage

Coverage rate: 3 - 4 square metres per litre depending on porosity and texture of substrate. The coverage is a guide only and will depend upon porosity and application technique.

Thinning

Not recommended.

Clean Up

Clean all equipment promptly with warm water and a little detergent followed by a fresh water rinse. Do not pour contents or washings down drains or sinks.

Precautions/ First Aid

It is recommended that normal personal protective clothing should be worn, including coveralls, impervious gloves and gog- gles. Avoid unnecessary skin contact and inhalation. Use a suitable respirator if spray application is employed. If swallowed, contact a doctor or the Poison Information Centre on 13 11 26. Give a glass of water to drink and do not induce vomiting.

Should skin contact occur wash immediately and very thoroughly with water. Seek medical attention if irritation occurs. If eye contact occurs hold eye open and wash continuously with clean water for at least 15 minutes. Seek medical advice. Refer to MSDS for more details.

This product is available from Bunnings