Removing moss and mould from brick pavers, walls, roof tiles and most porous surfaces.

Product: Bondall Moss & Mould Eliminator

Surface Preparation:

TEST AREA: Always test on a small inconspicuous area, to ensure that the product is achieving your desired result prior to application over the entire area.

Applications:

• Apply Bondall Moss & Mould Eliminator directly out of the container onto the entire area as other spores may be present not just in areas where mould can be seen.
• Ensure the Bondall Moss & Mould Eliminator is left for 24 hours on the surface before washing down.
• Areas that are heavily affected with moss and mould may require scrubbing while washing down.
• Once cleaned down the surface should be coated with a diluted form of Bondall Moss & Mould Eliminator (1 part Moss & Mould Eliminator to 2 parts water), then allowed to dry completely before applying Bondall paving & concrete Sealer or Bondall Natural Finish Sealer.

Coverage

Bondall Moss & Mould Eliminator will treat approximately 3 - 4 square metres per litre, depending upon porosity and texture of the surface.

Clean Up

clean all equipment promptly with mineral turps, followed by warm water with a little detergent and a fresh water rinse immediately after use. Do not pour contents or washings down drains or sinks. Dispose as per your local council regulations.

Precautions/ First Aid

It is recommended that normal personal protective clothing should be worn, including coveralls, impervious gloves and goggles. Avoid unnecessary skin contact and inhalation. Use a suitable respirator if spray application is employed. Refer to MSDS for full details. If swallowed, contact a doctor or the poisons Information centre on 13 11 26 and rinse mouth and throat with water and seek medical attention. Should skin contact occur, was immediately and thoroughly with water. Seek medical attention if irritation occurs. If eye contact occurs, hold eye open and wash continuously for at least 15 minutes. Seek medical advice. Material Safety Data Sheet available on request.