Removing unsightly bore, rust and tannin stains on concrete, brickwork, pavers, painted surfaces and fibro sheeting.

Product: Bondall Bore & Rust Stain Remover

Surface Preparation:

Area to be treated should be saturated with water, but not ponding prior to application.

TEST AREA. Always test on a small inconspicuous area, to ensure that the product is achieving the desired result, prior to application over the entire area. Some surfaces may be affected by bleaching from this application.

Applications:

For light stains mix 1 part Bondall Bore, Rust & Tannin Stain Remover with 1 part water and apply to affected area with a brush, roller or low pressure spray. Wait approximately 2-5 minutes then wash down thoroughly with water. (Do not allow to totally dry before washing down).

Areas that are heavily stained may require further treatment. When applying near lawns and gardens, be careful not to splash onto plants. Should this happen immediately flood the area thoroughly with water to neutralise chemicals.

Thinning

For badly affected areas use undiluted. For light stains dilute 1 part Bore, Rust and Tannin Stain Remover with 1 part water. Ensure adequate ventilation during use.

Precautions/ First Aid

It is recommended that normal personal protective clothing should be worn, including coveralls, impervious gloves and goggles. Avoid unnecessary skin contact and inhalation. Provide adequate ventilation. If swallowed, contact a doctor or the Poison Information Centre on 13 11 26. Give a glass of water to drink and do not induce vomiting.