APPLYING ONTO UNTREATED TIMBER DECKING

Product: Ecocel Timber Decking Oil

Surface Preparation:

Carefully clean and prepare all surfaces, fine sanding and rounding off sharp edges as necessary.

Remove all previous paint, varnish, shellac or lacquer and wipe the surface clean of dust. Stir often throughout application to ensure an even coat.

Applications:

• Stir well for 5 minutes and then apply with a soft paintbrush, applicator pad or suitable spray.
• The first application is a sealer coat. Thinning is not usually necessary but if you prefer, thin with 5% clean water and apply as above.
• Leave this coat to dry for 1 hour, fill any imperfections and then leave to dry fully for 4 hours before applying further coats.

Coverage

Approximately 16 square metres per Litre depending on texture and porosity of surface.

Drying Time

Ecocel Timber Decking Oil will be touch dry in 4 hours but it is recommended that the product be left a minimum 24 hours before recoating. Drying times are a guide only. Longer drying times may be required in cooler or humid conditions.

Clean Up

• Wash your equipment in fresh water with a drop of detergent.
• Rinse in clean water.
• Seal washings and unwanted leftovers and dispose of responsibly.

Precautions/ First Aid

It is recommended that normal personal protective clothing should be worn, including coveralls, impervious gloves and goggles. Avoid unnecessary skin contact and inhalation. Provide adequate ventilation. If swallowed, contact a doctor or the Poison Information Centre on 13 11 26. Give a glass of water to drink and do not induce vomiting.

Disclaimer

The information contained here is given in good faith and is intended to be of assistance to users. The performance of this product is dependant upon its correct preparation, application onto a sound surface and attention to the instructions on the label. The wide variety of surface conditions makes it impossible for the company to assume liability for any loss, consequential or otherwise, arising from the use of this product. Should the product be found defective our liability shall be limited to the replacement of the product only. We reserve the right to amend specifications and application techniques without prior notice.