APPLYING ONTO UNTREATED TIMBER

Product: Ecocel Gold Stain & Varnish

Surface Preparation:

Surface preparation is important. All surfaces to be coated with All Purpose Timber Sealer should be clean and dry, free from wax, oil, grease and other contaminates. fine sand and ensure all sharp corners and edges are rounded off and then thoroughly dusted.

All previous paint, varnish, shellac or lacquer must be totally removed before coating with Monocel Gold. A wood stain can be applied at this stage if required.

Allow sealer coat to dry a minimum of 4 hours before filling any imperfections with a suitably coloured putty/stopper. Allow to dry for 24 hours before lightly sanding and proceeding with subsequent coats.

Applications:

Stir well for 5 minutes and then apply with a soft paintbrush, applicator pad or suitable spray. The first application is a sealer coat. Thinning is not usually necessary but if you prefer, thin with 5% clean water and apply as above. Leave this coat to dry for 1 hour, fill any imperfections and then leave to dry fully for 4 hours before applying further coats.

• Do not apply if temperature is below 10 ºC or if rain is expected within 24 hours.

Coverage

Up to 16 square metres per litre depending on the porosity and application technique.

Gloss Level

Gloss

Drying

Leave the sealer coat to dry fully for 4 hours then apply a further 2-3 undiluted coats. Allow 4 hours drying time between each coat. We recommend you give your newly sealed timber a light sanding with 240-grit sandpaper, dusting off thoroughly with a tack rag, before proceeding to apply the undiluted coats.

Clean Up

Wash your equipment in fresh water with a drop of detergent. Rinse in clean water. Seal washings and unwanted leftovers and dispose of responsibly.

Precautions/ First Aid

It is recommended that normal personal protective clothing should be worn, including coveralls, impervious gloves and goggles. Avoid unnecessary skin contact and inhalation. Provide adequate ventilation. If swallowed, contact a doctor or the Poison Information Centre on 13 11 26. Give a glass of water to drink and do not induce vomiting.

 

Disclaimer

The information contained here is given in good faith and is intended to be of assistance to users. The performance of this product is dependant upon its correct preparation, application onto a sound surface and attention to the instructions on the label. The wide variety of surface conditions makes it impossible for the company to assume liability for any loss, consequential or otherwise, arising from the use of this product. Should the product be found defective our liability shall be limited to the replacement of the product only. We reserve the right to amend specifications and application techniques without prior notice.



Bondall's Timbercare Forum

Click to contribute to the discussions in our Timbercare forum.

For further advice contact the Bondall Building and Renovating Service on 1800 810 123 or (08) 6272 3800